Heinrich Company
GET A GRIP WITH HEINRICH

(14-1) Here are four drill heads and three Grip-Master Vises set up to drill and chamfer three holes, and tap two holes.

(14-2) This is the part after the work is done.

(14-3) The first operation is to drill the two large holes. Notice the small fixture that fits inside the vise jaws. This allows the Grip-Master Vise to be used for other applications.

(14-4) The next operation is the one smaller hole. There is no need to take the part out of the vise. The operator just slides the vise under the next drill head.

(14-5) Then three holes are chamfered, both sides. Notice how nicely the part sits on the jaw inserts

(14-6) The part is then put into another Grip-Master under the tapping head.

Go To Page
 1 2 3 4 5 6 7 8 9 10 11 12 13 14
Back to Photo Index